It could be any one of the contacts. When the distributor was put in, depending on what type of motor it is, number one could be anywhere. You will need to bring number one cylinder to top dead center on the compression stroke and see where the rotor is pointing. That will be number one and set the rest of the plugs from that.
where is number one on a vortex 4.3 v-6 distributor cap
Integra Telecom was the number one software distributor in the United States in 2009. Integra telecom was honored my Mitel on July 22, 2009. The number one software distributor may have changed over the years.
I cannot answer this question.
number one wire will point to the number one cylinder
Yes the rotor should be pointing to the #1 cylinder when you are installing the distributor.
Bring number one piston on compression stroke up to TDC. Drop distributor in so that the rotor points to the number one pin inside the distributor cap. The clamp at the base of the distributor only goes one way so there is no timing with a light necessary, the ECM takes care of that.
The left bank is 1,3,5,7 and the right bank is 2,4,6,8. The distributor turns clockwise.
# 1 on the distributor cap faces to the FRONT / CENTER
18436572
To find where number one spark plug wire connects to the distributor, remove the distriutor cap and set number one piston at Top Dead Center (TDC). At TDC, the rotor should be pointing to where number one spark plug wire connects.
The marked # 1 position on the distributor cap faces to the FRONT / CENTER
no1 on the distributor always points towards the no one cylinder