If you follow the exhaust pipe out from the back of the engine you will see a cable going to the oxygen sensor in the exhaust pipe. You will need a special type of socket to remove the oxygen sensor which you can buy at an auto parts store.
It is screwed into the exhaust manifold.
what is the oxygen sensor location on a 1993 oldsmobile cutlass ciera 3.3l v6
It is in the driver side exhaust manifold.
Code 52 on a Dodge Lancer 2.2L turbo means the oxygen sensor signal input indicates a rich air/fuel mixture ratio condition during engine operation.
IN THE EXHAUST PIPE, JUST ABOVE THE CONVERTER.
Code 44 in any GM automobile including the 1987 Buick, means that the oxygen sensor is faulty. The oxygen sensor regulates how much air goes into the motor for combustion to occur.
the oxygen sensor is in the exhaust manifolds, there should be one for each side
The CA20E Engine has one oxygen sensor installed in the exhaust manifold.
O2 sensor in the exhaust manifold near the engine
The oxygen sensor on the 1987 Dodge D150 1/2-ton pickup with 2-wheel drive and a 3.7 liter 1Bl 6-cylinder engine is mounted in the exhaust manifold, next to the transmission bell housing. Check under the hood in the rear engine area on the driver's side.
On the block , Rear Passenger Side by Firewall , Left of the Distributor
Honda oxygen sensor is usually positioned in the exhaust manifold downpipe before the catalytic converter of your Honda vehicle or in the middle of the two mentioned components. For more details: http://sites.google.com/site/hondarepairsite/home/2004-honda-oxygen-sensor