20 amp on a 12 volt system
Use a 20 amp fuse or breaker.
No. If you use a larger fuse you are not protecting the device which has a rating of a lesser value.
4800
It is a fuse that is rated in one thousandths of an amp. An example, a 500 mA fuse can also be called a 1/2 amp fuse.
In the Power Distribution Box ( which is " live " ) in the engine compartment : Mini fuse # 1 is a 30 amp fuse for the PCM relay Mini fuse # 2 is a 10 amp fuse for the PCM and front electronics module Mini fuse # 5 is a 15 amp fuse for the PCM and fuel pump motor
In the power distribution box, in the engine compartment of a 1997 Explorer, (PD BOX IS LIVE - DISCONNECT YOUR BATTERY CABLES ) in location # 2 there is a 30 amp maxi-fuse for the PCM power relay in location # 11 there is a 20 amp maxi-fuse for the PCM MEMORY and horn Relay# 5 is the PCM POWER RELAY and diode # 2 is the PCM DIODE ----------------------------------------------------------------------------------------------------------- In your fuse panel - visible with the driver's door open location # 13 - 15 amp fuse - for PCM system/stoplamps/AWD/ABS/speed control/ trailer tow location # 19 - 25 amp fuse - for PCM system/ ignition coil
They should be in the engins compartment fuse/relay panel.
I have seen a bad starter do this
20 amp body fuse 20 amp body fuse #15 on the fuse block 25 amp body feed fuse
The 1965 Chevrolet Impala SS fuse box requires a 20 amp fuse for the taillights. A 30 amp fuse can be used when a 20 amp fuse is not available.
fuse number 1 is 10 amp fuse 2 is 25 amp fuse 3is 25 amp fuse 4 is a spare fuse 5 is 10 amp fuse 6 is a spare fuse 7 is 20 amp fuse 8 is 25 amp fuse 9 is 20 amp fuse 10 is 5 amp fuse 11 is 5 amp fuse 12 is a spare fuse 13 is 5 amp fuse 14 is 15 amp
20 amp a 20 amp fuse
The purpose of a fuse it to protect the wire that goes to the load. A 15 amp fuse protects a #14 gauge wire. A 20 amp fuse protects a #12 gauge wire. To answer your question if the wire size is #12 coming from the 15 amp fuse now then it can be upped to 20 amp fuse. If it isn't then you are taking the risk of overloading the #14 wire with a 20 amp fuse. This can lead to insulation failure of the #14 wire, overheating with the possible outcome of a fire breaking out somewhere in the circuit.
In the power distribution box in the engine compartment ( which is " live " ) Maxi-fuse # 11 is a 20 amp fuse for the horn and the PCM memory Also , relay # 2 , in the PD BOX is the horn relay
no you cannot, it is dangerous, you need to have a 20 amp service installed in order to do that. hope i helped
It should be a 25amp fuse. start checking coils, or PCM.