Starter solenoid hides in behind Master Fuse housing at the back of the Battery case. On my bike the fuse housing was changed somewhat after market so I am not sure how hard it will be to get to yours.
Asked in Ford F-150
Where can I find the wiring schematic for a 1988 F150 305 starter soleniod?
a soleniod is just one item in a schematic its like a big relay if it needs to be replace its like 8 bucks, if you want the schematic for the whole starter system its basically battery+ to soleniod to starter to battery- ...
You started your 1997 f-150 and everything was running fine until you shut it off and now the starter is not working you have heard this is not a problem with the starter Any specific ideas?
You should check the soleniod by the battery mounted on the fender if that is not the problem the it is probably the soleniod on the starter. Had the same problem on mine until i tap the soleniod on the starter. ...
What is wrong when a 1994 Oldsmobile Royal cranks 5 days a week every week then 1 day a week it doesn't crank for a day then next day for next 5 days it cranks what is it?
your starter soleniod may be stuckif you are getting dashboard lights and the starter won't turn overhit the soleniod with a hammerif your car turns over replace the soleniod ...
Asked in Mercury Cougar
Where is the starter located on a 1999 Mercury Cougar?
Follow your positive cable(usually red) from your battery to your soleniod. From there it should run into the starter. The starter on a v6 is under the intake manifold. ...
Asked in Honda Motorcycles
Will a starter from a 1979 goldwing fit a 1980 goldwing?
'79 is a 1000 cc , '80 is a 1100 cc. You would have to compare the both. Or check with the parts dealer. ...
Asked in Cars & Vehicles
New starter but i think the soleniod is bad because it wants to start by itself what do you think?
i dont think it is the solenoid. more likely to be a bad ignition switch or a short in the new starter ...
Where is the starter solenoid located on a 1993 Cadillac DeVille?
On the 1993 Cadillac 4.9L the soleniod is located atop the starter.The starter is afixed directlyto the side of the motor at the front of the car behind the radiator. ...
How to replace the starter in a 1986 Honda accord?
1. Disconnect the battery negative terminal 2. Disconnect the leads to the Starter Soleniod (the cylindrical thing on top of the starter) 3. Remove bolts attaching the starter to the engine 4. Remove Starter 5. Installation is the reverse of these instructions. Hope this helps... ...
Asked in Transmission Fluid, Honda Motorcycles
Where does the transmission fluid go on a 1976 Honda goldwing 750?
First, Honda did not mak a "750" Goldwing. In 1976 the Goldwing was a 1000 cc machine known as the GL1000. As for transmission fluid, the 1976 GL1000 does not use transmission fluid. It has a wet clutch, and the engine oil provides all the lubrication that the clutch and transmission requires. For this reason it is extremely important to use the correct engine oil and change it at regular intervals. For detailed information check out www.randakks.com. ...
Where is the starter relay for a 1988 Dodge van with a 318 engine with air conditioning?
The starter relay operates the starter soleniod. The relay is located on the firewall at about the 8 O'Clock position looking at the brake booster. It has 4 wires in one connector going to it. ...
Asked in Eagle Talon
You swapped the motor out of your 91 eagle talon now there is no power to your starter all you can hear is the relay clicking you need help fast cant figure it out?
Check the main ground to your starter. It sounds to me like your soleniod has power, but you starter motor doesnt. ...
Asked in Chevy S-10, Ford Bronco, Motorcycles, Spore
How do you install a Starter on a 1983 Honda 1100 Goldwing?
remove battery cable remove gear change lever remove two bolts thru starter then work it out .' that's it ...
Asked in Car Starting Problems, Cadillac
Cadillac wont start or turn over?
No car can start until it turns over. Meaning the starter has to engage. So you have at least one problem or more. You have to have a good battery and it has to be 12.6 volts and remain at 8-12 vol;ts while trying to crank. When you cut the ignition on - the instrument panel has to light up and when you go to "start " you have to hear a soleniod in the starter go clunk. No clunk?...
Asked in Chevy Suburban, Chevy Trucks and SUVs
How do you replace a solenoid on a starter for a 1995 Chevrolet Suburban?
disconnect your battery. Remove your starter from under your truck and on the top of the starter is the soleniod. unbolt it, and bolt on your new one. Make sure that the spring and the teeth line up on the starter. replace pos. cable if needed. reinstall starter. Check all your other cables to make sure that they are ok. Later ...