answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Where is the 1996 Buick Skylark windshield drain located?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the radiator drain plug located on 1997 Buick Skylark?

It's on the Driver's side near where the headlight is.


How do you drain the radiator located on a 1993 Buick Skylark 3.3L V6?

If there is no petcock on the bottom of the radiator then you must remove the lower radiator hose to drain it.


Where is the radiator plug in your 91 Buick Skylark?

You can find the 1991 Buick Skylark radiator drain plug on the bottom of the radiator. The radiator drain plug will be in the center of the radiator bottom.


Where is the1999 Buick Skylark oil pan located?

For the V6, it's in front of the transmission pan. The drain plug is right there.


You have an oil leak coming from your 1998 Buick Skylark what could it be?

There are several causes of oil leaks in a 1998 Buick Skylark. It could be a gasket, a bad seal, or even a drain plug.


What size wrench is needed to remove a 1996 buick skylark oil drain plug?

15mm.


Where is the cowl drain on 1997 Buick Skylark?

I think it's on the passenger side. A lot of debris can get in there.


Where is the oil pan located on a 1996 Buick Skylark?

If you have a V-6, it's right in front of the transmission pan. You'll see the drain plug right there. It's a 15mm plug.


Where is the 2005 Buick lacrosse radiator drain plug?

Is there a drain plug on a 2005 Buick century


Where is radiator drain plug on 1994 buick skylark?

It is located below the radiator hose on the battey side. It should be a small white plug. Turn the pull out. It will remain attached so don't try to disconnect it.


How to drain gas tank of 1989 Buick Skylark?

use a section of 5 ft hose and suck on it till gas comes out to syphon


Where is the oil drain plug on a 1997 Buick Skylark?

If you have a 3.1 V6, it's just in front of the transmission fluid pan. Use a 15mm box wrench for it.