The 1997 Saturn knock?æsensor is located on the back of the engine. The knock sensor can be removed by removing the wiring harness and the retaining bolts.
The knock sensor is located on the backside of the engine to the left of the oil filter, it is round with a 1 wire plug on it and a round base. I do not know the torque spec, but when I replaced mine I made it tight enough not to back out on its own.
the knock sensor is located under the intake manifold, with a flash light you can see it however you have to remove the intake manifold to replace the knock sensor , also you will need to replace the intake gasket set as well!
The knock sensor for a 3.5 Honda engine is located on top of the motor under the intake. It is about a 1.5 hour job to replace it.
The knock sensor for most Nissan V6 engines is located directly under the intake manifold. So to replace it, you have to remove the intake manifold. Good Luck.
Because the boys that designed them never had to replace one of them.
The sensor is located under the intake manifold. It takes about 2 and half hours to replace the intake manifold, book time. Knock sensor is about $35 + $60-$90/hr labor. So you are talking about $300.
can you tell me where the knock sensor is located on a 3.3l mercury villager
The knock 1 sensor on a Vortec 4.8 is located on the top of the engine. You will have to remove the intake to gain access to replace it.
The knock sensor for a Pontiac G6 is located on the side of the engine. It is mounted at the exhaust manifold.
the Knock sensor is located behind the Harmonic balancer pulley. on the bottom sidethe sensor is $95.00 remove the lock down screw unplug and replace
how do I disconnect the Electrical connection on knock sensor
The knock sensor is located below the intake manifold