Nissan Pathfinder

Where is the knock sensor in a 97 Nissan Pathfinder and how can you replace it?

363738

Top Answer
User Avatar
Wiki User
Answered
2006-04-03 12:50:17
2006-04-03 12:50:17

The knock sensor for most Nissan V6 engines is located directly under the intake manifold. So to replace it, you have to remove the intake manifold. Good Luck.

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


how you can remove the knock sensor from a 1996 Nissan pathfinder i need a picture


You can find a 1996 Nissan Pathfinder knock sensor picture in most auto repair manuals. Most Nissan dealerships repair centers will provide you with a picture of the sensor.


Where is the knock sensor for a 99 pathfinder



how many gaskets and which ones are needed when you replace the knock sensor on a Nissan frontier w/a 3.3l v6 engine?


If just the knock sensor need to be replaced. I would say no more than $150.00


everyone one is telling me it is located under the intake or intake manifold, and that if must be removed..


I bought one off the internet for around $50, but found out it cost about $450 in labor to have it replaced.


the Knock sensor is located behind the Harmonic balancer pulley. on the bottom sidethe sensor is $95.00 remove the lock down screw unplug and replace


the knock sensor is located under the intake manifold, with a flash light you can see it however you have to remove the intake manifold to replace the knock sensor , also you will need to replace the intake gasket set as well!


The detonation sensor ( knock sensor ) really cannot be checked by the home mechanic it is either good or bad. It consists of a pressure sensing piezoelectric element that converts pressure differences into electrical signals that can be read by the computer.



I AM GETTING A OBD CODE ERROR FOR MY 2000 NISSAN QUEST , PO141 AND PO325 ??? HOW DO I FIX IT..


The knock sensor is located below the intake manifold


The knock sensor is located below the intake manifold


The knock sensor on Nissan 300ZX non-turbo from 1990 thru 1996 is located below the lower intake manifold on the rear of the engine block. To replace the knock sensor the upper and lower intake manifolds need to be removed. It is always best to replace the knock sensor with a new one considering its major dissasembly.


how do I disconnect the Electrical connection on knock sensor


where is the knock located on 2001 nissan altima 2.4


how to replace a knock sensor on a 2000 Chevy 6.0 step by step


how to replace a knock sensor on a 2002 hyundai elantra


The knock sensor is located below the intake manifold


Th knock sensor on a 2002 Nissan Xterra 3.3 is located on the top of the engine. It is mounted under the engine intake.


Disconnect the wire from the sensor, use an open ended adjustable wrench to unscrew it. take a new sensor and screw it in. on a different model (if not a standard sensor) there is a nut and bolt holding it in, use the steps above to replace it


The 4.8, 5.3 and the 6.0 GM engines require removing the intake manifold to replace a knock sensor.


Where is the knock sensor for a 2003 kia spectra



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.