Probably the shift linkage in that model.
Check the transmsission fluid level May be time for a rebuild
Worn trans or diff parts. If it gets worse, have it looked at.
It is important to know the location of the different car parts. The Reverse Gear Light Switch is located on top of the gearbox in most cars.
I have the same problem right now and im trying to figure it out. if you have any suggestions i would be glad to take them...but i think its the Neutral safety switch but im not 2 sure yet.
on the gear shifter
it sounds like your neutral safety switch
insufficient engine output incorrect gear (transmission not in 1) drag (as from brakes or a trailer or overloaded or flat tire)
It is located on the gear shift handle.
on the side of the gear box
On the transmission!!
Underneath the front cover in front of the transmission. It is part of the gear selector switch. It switches off of the shifter drum.
probably located on top of the gear box
my buick will not start ,gear shift will not move, no cranking sound, all I get is light on dashboard . horn works , headlights work, battery is new(less than 1 mth old) my buick will not start ,gear shift will not move, no cranking sound, all I get is light on dashboard . horn works , headlights work, battery is new(less than 1 mth old)
I went crazy looking for the door jamb switch on my 2001 Denali. It's attached to the locking mechanism inside the door. The latch has a gear which drives a mating gear that activates the switch. When you pull the door handle, the latch opens and the gear moves.
Under the gear sift
It is a switch that indicated what gear or gear range the trans is in.
Just right into the test stick , check level with engine running, apply gear shift back and fore then parking before checking level
The neutral safety switch on a Dodge Dakota will keep the engine from starting when the truck is in gear. It is located in the transmission case.
There is no "switch". To cancel overdrive move the gear lever from "D" to "4".
Usual location is in the pressure line between the pump and gear.
On the 2000 Ford Explorer XLS model, it is a push button feature that is located on the Gear shift on the Steering column.
I'm assuming you mean the inhibitor switch. ie the car shouldn't start in gear for auto trans. it's located on the passsenger side of the trans. it's the plastic unit which the gear shift selector goes through.
I have a 2000 buick regal LS I recently found out there is an override for the gear shift, mine is located on the steering column under the steering wheel. There is a small plastic cap, pop it off, then use a screw driver press the button. This worked for me. Good Luck
the back up light switch is located in the gear shifter console