What engine? On the 2.4L LD9, it's underneath the engine IDI (integrated direct ignition) cover... the big white plastic housing..
1999 Alero how do i test ignition coil pack
remove the ignition coil/module cover from top of engine. 4 bolts, if the spark plug boots adhere to the spark plugs, remove them with a wire puller or simillar. and install them on the secondary housing terminals. the boots must be installed on housing plate before instalation or you may damage the boots. remove the ignition coil housing screws 4 screws. and remove the housing, then remove the coils.
How do I get to the bottom bolt on the coil pack of my 2000 Camry
Depends on the engine .. if its a 3.1 or 3.4 they are on the top of the engine at the back near the firewall. There are actually 3 coil packs each one controls 2 cylinders.
These cars do not have a distributor or gasket. They are run on a coil pack which is controlled by the ECM.
The coil pack on a 2000 Pontiac Sunfire is located behind the air intake hose. Just behind where the air intake hose connects to the top of the motor is where the coil pack is on this vehicle.
How do I install a coil pack for Hyundai sonota 2000
coil----3---4 pack---2---6 plug----1---5
auto zone will check your codes for FREE. if you have a bad coil pack they will tell you.
The COIL PACK TOWERS are numbered : coil----3---4 pack---2---6 plug----1---5
The 2000 Saturn does not have a distributor. Instead it uses a "coil pack" system.
remove the plastic engine cover from top of engine, you will have to pull the fuel rail as it runs above the coil packs, remove the screw that holds the coil pack and unplug the harness then pull coil pack and plug wire assembly out.