0
The COIL PACK TOWERS are numbered : coil----3---4 pack---2---6 plug----1---5
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Is there an access door for a fuel pump on a 96 4 door 4x4 40L explorer?
No door. You have to drop the tank.
How many cm3 are in 40L?
40L = 40000cm3
Engine removal procedure98 explorer 40L V6?
Get a Haynes or Chiltons manual from an auto parts store and don't forget to label everything.
Can you fit a 50 mustang engine in a 1993 ford explorer xlt 2x4 40l v6?
i would deffinatly say yes since some of the year models came with a 5.0 stock.
Would a gasoline tank hold about 40ml or 40L?
On a car, 40 liters.
The person name that killed Aaliyah?
The pilot-operator of the Cessna 40l which fatally crashed.
Where is the fuel filter on a 1995 Jeep Wrangler 40L?
Look under vehicle foolow the fuel line from the tank
Where is the fuel filter on a 1997 Jeep Wrangler 40L?
It's part of the fuel pump assembly located inside the gas tank.
Where can you find a vacuum hose schematic for 1995 40L AWD aerostar?
It is located underneath the hood. You might have to clean it off with a rag to read it.
What is the oil to petrol mix for a dt15 suzuki outboard?
My mechanic says 100:1 I have done this for 40l last season without a problem
What would cause a ticking sound under the valve cover of a 1998 Ford Explorer 40l SOHC?
the 4.0l s.o.h.c. enging has a timing chain tensioner kit. wich is suposed to fix the slight ping on start up. check with your locad dealer with your VIN # and have them check to see if you have any RECALLS on that issue.. ie only fix if the prob is thier..
Your 1993 wrangler 40L inline six will crank and rollover but will not start replaced distributor wires plugs starter ignition coil map sensor throtle position sensor fuel pressure good?
If it's not the crank sensor, it's probably the ECM, and that's bad. Try you crank shaft position sensor, if it is bad the engine will not run. It's on the back of the engine just below the vavle cover on the drivers side You can also try the ignition pickup. It's a little back plastic plate that sits on top of the distributor when you take the cap off.
