0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the data link connector located in a Kia Rio 2001?
DLC connector on the kia rio is available up to 1995.
Where is the dlc on a 2002 Chrysler Sebring lx?
The data link connector is under the dash on the driver side.
What does DLC stand for in 2002 vw fuse legend?
DLC = Diagnostic Link Connector (Commonly known as the OBDII connector) located under the dash on the driver's side.
Where is dlc connector located in vw touran?
It´s located below the steering wheel in the crentral electronics bay.
Where do you hook up a obdll scanner?
The OBD II DLC (data link connector) in most vehicles (1995, 1996 and up) is located just under the dash on the drivers side.
Where is the obd2 connector located on 1999 Mercedes ml430?
It's called the Data Link Connector (DLC) and is found above the emergency brake pedal.
Where is the dlc computer connector located in 95 vw jetta?
The connector is located right next to the ashtray, behind a small plastic cover. Remove ashtray and slide cover to the left.
Where is the data link connector on a 1999 Jaguar xj8 Vanden Plaus?
The DLC connector is located under the dash on the drivers side, above the acellerator pedal and attached to the console.
Where is dlc connector located in 2001 vw cabralo?
next to the ashtray under a cover that slides over to the left after removing ashtray
Where is the OBD II port in a 2006 HHR?
By law the DLC (Data Link Connector) has to be located within 18" of the steering column.
Where is the OBD-ll DLC on a 1995 Chevrolet Lumina with 3.8L engine?
The data link connector will be under drivers side panel (above your legs ) .Look under you will find the connector, either on left or right usually behind a plastic cover stating (data link connector).
Where is dlc connector on 1991 Volvo 740?
where is the diagonistic tester located on a 1991volvo740 It is located on the drivers side of the car under the hood to the front of the hood hinge. This system is not OBD2 so the codes have to be read either manually or by a scan tool with a 6 prong connector.
