Nissan 300ZX

Where is the ECU located on a 1987 Nissan 300ZX non-turbo?


Top Answer
User Avatar
Wiki User
2009-12-19 11:49:01
2009-12-19 11:49:01

It is located behind the passenger side kick panel


Related Questions

Where is the ignition control module on a 1987 nissan 300zx

On my '86, 300zx NA, the rocker switch on the console turns on the heated outside mirror (drivers side).

First, what year and car are you asking about? 1987 Nissan 300zx

i can't find the iat sensor for my 1987 nissan 300zx non turbo

To install a thermostat on a 1987 Nissan 300ZX, remove the two nuts and one bolt on the lower water neck. Slip off the old thermostat and use a gasket sealant to secure the new thermostat.

The fuel tank capacity is 19.0 gallons i have an 87 300zx and it only has an 8 gallon tank.

Remove the radio and the fuse is behind the radio

I have 255,000 on a 1987 Nissan 300zx and still running strong. As long as you maintain the car and change the oil evry 3000 mi it should last a long time.

In the thermostat housing on the front of the engine were the radiator hose attaches

The AC system from a newer Nissan 300zx can be retrofitted to a 1987 with a serious vacuum problems by making a number of modifications. New mounting brackets, wiring, refrigerant, and AC hoses will be needed.

Until you say what is wrong, I recommend using a sledge hammer.

no the 85 it is on the fuel pressure reg it should be the same

In fact any turbo can be used on any turboed car. It will just have to be custom fitted. The real issue here is that the 94 Z is twin turbo while the 87 Z is single turbo.

You can find the 1987 Nissan 300 your pump relay switch in the fuse box. The fuel pump relay switch will be at the top of the third column.

Lining worn to to improper use? Rear engine seal leaking on clutch? Improper adjustment?

The temperature sensor on a 1987 Nissan Stanza is located on the rear of the radiator. It is about one-third of the way down from the top.

You can find the PCV valve for your 1987 Nissan on top of the engine. The PCV valve will be near the air filter housing.

above the oil filter,to the left.

Remove steering wheel disconnect Quick Connects unscrew switch and pull out put back in same way

Check the alignment of your pully and also look for a cracked or broken pully.

if it looks the same shape as the old one yes

Yes. It is a direct fit. Nissan didn't change the rear hatch and they are interchangeable. 1984-86 won't have the third brake light. 1987-1989 will and you'll have to wire that in if you want it to be operable.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.