according to the emissions label it does not have an EGR valve.
It does not have one
There is no EGR valve on this generation of Corolla. This engine is equipped with VVT-i (variable valve timing with intelligence), that allows it to perform the function of EGR without the former EGR hardware.
The Geo Prism and Toyota Corolla were assembled in the same factory on the same assembly line using the same engines. The EGR valves should be virtually identical.
I HAVE NOTICED THAT FROM 87-92 MANY AUTO MAKERS DID NOT USE AN EGR VALVE...EXAMPLE 88FORD TAURUS,92 TOYOTA COROLLA
The EGR Valve on a 2006 Corolla is located on the driver's side of the motor at the very top of the valve cover. Look for a disk shaped valve that kind of looks like a flying saucer. It has two small hoses coming off of it that are connected to the EGR Valve Modulator.
If you're corolla is a 92' model then it doesn't have one. If engine ping is you're problem then good luck.
The PCV valve on a 1998 Toyota Corolla is located on top of the engine, on the passenger side. It connects the intake manifold with the valve cover.
The egr valve is located on the top of the engine on the right hand side
where abouts is a egr valve in a 02 avensis d4d
The PCV valve on a 1987 Toyota Corolla FX16 is located behind the alternator. It is under the intake manifold.
what isa the valve adjustment of a 4A engine toyota corolla
The egr valve is located on the top rear of the engine. It bolts on and is easily removed.
On my Toyota engine it's to the right of the intake manifold.
Check the emission label usually located on the top of the radiator or on the core support just in front of the radiator. You will see a diagram of all the vacuum lines and emissions equipment. Generally-the EGR valve is located near the throttle body.
No but if there is still an EGR valve problem then its the EGR Valve switch located at the back of the motor. I replaced my EGR valve 2 times before I figured out it was the electrical switch, which had burnt up, for the egr valve. I havent had a problem with the EGR since then..
The egr valve is located on top of the engine. It is close to the firewall, mounted close to the center from side to side.
there isn't one
It is on the throtle body.
16 valve and double overhead cams
Remove the heater control valve and replace it.
no it will not...
You more than likely have a clogged egr port. Remove the EGR valve and clean the ports going to the engine with carb cleaner.
Behind the intake manifold on the firewall side.