If you are looking at a 1995 Chevy Silverado with a 5.7 liter or 5.0 liter you will not find an IAT (Intake Air Temperature) sensor. 1988 thru 1995 Chevy V-8s have TBI (Throttle Body Injected - looks like a carburetor but has two electronic fuel injectors at the front underneath an old-style-looking air filter housing) that uses a MAP (Manifold Absolute Pressure) sensor to control air-fuel delivery. I know because I have worked on many.
The 1995 Chevy Silverado coolant sensor is located on the front of the engine. The coolant sensor will be a few inches above the thermostat housing.
That year did not use a crankshaft sensor. It used an ignition module.
right in front of the catalitic converter
That sensor was not used on that year. IT DON'T HAVE 1
YES, It will bolt right in.
A 1995 LT1 engine can be put into a 1995 Chevy Silverado with minimal changes. This will increase the overall power and performance of the vehicle.
YES, They will fit with no problems.
You have to remove the transmission to get to the clutch slave cylinder on that truck. You can pull the engine if you want and get to it. YOUR CHOICE.
That would be the accumulator for the Air Conditioning system.
rpm and speedometer gauges not working 1995 Chevy silverado 2wd
The crankshaft position sensor on a 1995 Chevrolet Silverado is located on top of the timing case. The part can be purchased at any auto parts store.
The 1995 Chevy Silverado is manufactured by General Motors. Today they can be purchased from anywhere between $4,000.00 and $6,000.00 depending on the seller.