Ford Tempo
Chevy S-10
Mercury Mountaineer

Where is the IAT sensor on a 93 Ford Tempo?

646566

Top Answer
User Avatar
Wiki User
Answered
2005-03-31 03:02:56
2005-03-31 03:02:56

It's located in the rear of the air box. If you remove the lid off the air filter box and look inside under the filter you will see a orange tip sticking through the side of the box. That is the IAT (Intake Air Tempurature) sensor.

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


93 thru 99 3.0 motors have IAT but later models do not


The 1993 Chevy S 10 Blazer IAT sensor can be found on the top of the transmission. The IAT sensor will be near the front of the transmission.


The IAT sensor is located on the intake manifold air cleaning housing or air duct.


how do you replace front door actuator for 93 ford tempo


The factory spec for tires for a '93 Ford Tempo is P185/70R14.


it is located in side the maf actually they use the same sensor housing.


The IAT intake air temperature sensor plug on a 93 Nissan is on the intake pipe. The EGR sensor is located on the intake manifold.


The IAT sensor on the 1993 Honda Prelude is located to the right of the intake manifold as you face the engine compartment. It is connected with red and green wiring.




The factory spec for tires for a '93 Ford Tempo is P185/70R14. As far as I know it would be the same for all years.


The intake air temperature sensor is inside the main plastic housing of the air intake box where the air filter resides.


Down the tube that holds trans dipstick.


The engine compartment fuse and relay box in a 1993 Ford Tempo is on the fender wall. It is located on the same side as the battery.


On the 323 and 95 1.8 liter, the Mass Airflow Sensor and the IAT are in one unit. I'm not sure which wires are which on your car but I believe it's the green/pink and red/black wires. Hope this helps! -Christian Riehlc@rider.edu



Should be in the trunk on the drivers side inner fender.



There is very little chance this will work.I believe the Tempo is much closer in design to the Escort series than the larger Taurus/Sable.Personally, I wouldn't pursue this particular effort. Find one from a Tempo/Topaz.


because everyone elses 1993 ford tempos stall when they idle. learn to drive with one foot on the gas and one on the brake like I do in my '93 tempo. keep the RPM at 1000 and it won't stall out.


call the Ford dealer or a salvage yard near you. Looks good but might be a model year change there.


It stands for the Air Intake Sensor. Basically it is another sensor used by the computer to adjust fuel mixture for a good running car in cold weather. It is housed in the air filter flow assy unit.


Look under the Mainfold and it should be a screw on sensor.....it also might be in a black box protected under the manifold its usually in plain sight but consealed by the box. Edit from someone else: I have a BMW 1995 318is with the same engine (if you're in the US). The engine is M42 and was used on '92-'95 318 BMWs. The IAT sensor is integrated into the volume air flow sensor, it is not a separate sensor as on some other cars.


I cannot give you and exact location for the 93 but i can tell you that it will be on the air intake tubing or right near the throttle body...on my 96 it is on the intake tube closer to the throttle body..hope it helps a little


It doesn't have a knock sensor on the 4.0 L OHV in a 1993 Ranger ( my 1995 Ford Explorer 4.0 L OHV engine doesn't have a knock sensor either )



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.