it is located in side the maf actually they use the same sensor housing.
The IAT sensor is located on the intake manifold air cleaning housing or air duct.
The IAT sensor on the 1993 Honda Prelude is located to the right of the intake manifold as you face the engine compartment. It is connected with red and green wiring.
93 thru 99 3.0 motors have IAT but later models do not
The IAT intake air temperature sensor plug on a 93 Nissan is on the intake pipe. The EGR sensor is located on the intake manifold.
The 1993 Chevy S 10 Blazer IAT sensor can be found on the top of the transmission. The IAT sensor will be near the front of the transmission.
It's located in the rear of the air box. If you remove the lid off the air filter box and look inside under the filter you will see a orange tip sticking through the side of the box. That is the IAT (Intake Air Tempurature) sensor.
red/blue and red/white
How do you replace the ignition distributor on a 93 mx6 v6 pics?
The intake air temperature sensor is inside the main plastic housing of the air intake box where the air filter resides.
Look under the Mainfold and it should be a screw on sensor.....it also might be in a black box protected under the manifold its usually in plain sight but consealed by the box. Edit from someone else: I have a BMW 1995 318is with the same engine (if you're in the US). The engine is M42 and was used on '92-'95 318 BMWs. The IAT sensor is integrated into the volume air flow sensor, it is not a separate sensor as on some other cars.
On the 323 and 95 1.8 liter, the Mass Airflow Sensor and the IAT are in one unit. I'm not sure which wires are which on your car but I believe it's the green/pink and red/black wires. Hope this helps! -Christian Riehlc@rider.edu
The knock sensor for the 1993 Chevy Cavalier is located in the back of the motor. It can also be located in the engine valve.