answersLogoWhite

0

How do you replace the ignition distributor on a 93 mx6 v6 pics?

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Witch parts do you replace in manual transmission when it brakes in a 93 4 cil Mazda mx6?

How long is a piece of string ????


What does an ignition module looks like and where can you find it on your 93 Honda accord?

inside distributor under cap (expensive) Honda calls it an ignitor its part of the distributor actually it is the distributor


Where is the coil on a 1993 Ford Probe gt?

On the '93-'97 GT's the ignition coil is part of the distributor. If your coil goes bad you need to change the distributor.


How do you replace the igniter in the distributor on a 93 Honda accord?

You take it to a mechanic. If your asking, you shouldnt be attempting it.


Is my ecm on your 93 Chevy truck acting up it starts then dies after 1 minute has good fuel pressure restarts everytime but dies after about the same time.?

I would replace the ignition module in the distributor. Simple job.


No spark Ford Escort what should I do?

Please check your spark plugs,wires,distributor and rotor or the ignition coil module. My '93 LX has an ignition coil module.


What is 93 gm service engine code 12?

Domestic No spark from ignition control module or distributor or import (like Geo or Spectrum) No distributor reference pluses to ECM.


93 probe gt replaced mass airflow sensor car turning over not starting replaced distributor and wires - any suggestions plan to pull codes this evening?

Check condition of ignition coil. Replace if bad.


On a 93 Chevy cavalier- do you have to pull steering wheel to replace ignition switch?

yes


Why does your 93 Chevy 2.5 L 4-cylinder backfire and will not start?

Possibly the ignition got wet, check inside the distributor cap for moisture.


How do you replace the ignition switch on a 93 2500 Chevy?

You switch the carborator with the ac and then rewire the inside to the dashboard


How do you wire up a distributor for a 93 Chevy Camaro Z28?

To wire up the distributor for a 1993 Chevy Camaro Z28, first ensure the ignition is off and disconnect the battery. Connect the distributor's ignition coil wire to the positive terminal of the coil and the control wire to the ignition module. Make sure to line up the rotor to point at the number one cylinder's terminal when installing the distributor, and finally, reconnect the battery and test the ignition system. Always refer to a service manual for specific wiring diagrams and specifications.