The IAT sensor on the 1993 Honda Prelude is located to the right of the intake manifold as you face the engine compartment. It is connected with red and green wiring.
AnswerIts located on the intake manifold somewhere It is located on the driver's side of the intake parallel of the brake master cylinder.
in my bam b bam
In the intake manifold plenium, its a 2 wire sensor
how much does a iat sensor cost on a 2000 Honda accord
The IAT is located on the driver side of the intake plenum on an SI model. If you're standing in front of the engine, it is directly to the right of the label "PGMFI." It's a white plastic sensor.
It's located on the side of the intake manifold (driver's side) near the master cylinder reservoir. It's white & attached by 2 screws & has a 2 wire connector.
A 95 did not have IAT sensor
IAT (INTAKE AIR TEMPERATURE) IT'S LOCATED IN LOWER SIDE OF ADMISSION MANIFOLD,IN FRONT AT FIREWALL IN DRIVER SIDE.
it should be in the intake tube(black tube from your filter) theres like a sensor(IAT)on it
The 1996 Honda Civic came equipped with the 1.6L L4 engine. The idle air temperature (IAT) for this application will be located on the intake manifold hose. For reference the IAT for this vehicle is Standard Motor Parts/Intermotor #AX56.
The IAT sensor is located (from satnding in fron of the car looking at engine) on the right side of the intake manifold on the upper part but at the bottom of the upper part. It's usually white and has a plug to it of course, Ibeleive there is 2 screws/ small bolts holding it in...be careful not to break the electrical connector when removing , as it does get very hot right there and the plastic becomes brittle.
The IAT sensor should be located on the intake air duct tube between the air filter housing and the throttle body