answersLogoWhite

0


Best Answer

Right side of the stering wheel. Insert the key, turn clockwise and release when engine goes brumm.. brumm..

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the Ignition switch 2004 ford expolorer sport trac?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why my sport switch don't worck on my 2004 Cadillac CTS?

2004 cadillac cts sport switch don't work


Change ignition on 2004 Chevy Malibu?

can I switch ignition cylinder with a different ignition cylinder w/key in a 2004 chevy Malibu without having to use a passcode


How do you remove ignition switch 2004 Pontiac Montana?

pull it really hard


How do you install the ignition switch in a 2004 Pontiac grand am?

The ignition switch in a 2004 Pontiac grand am can be installed by first Sliding out old lock cylinder and then Press the small release tab While turning the key to the ON Position.


Will a 2001 ignition switch fit the 2000 Chevy Tracker?

Yes, the 2001 ignition switch for a 2000 Chevrolet Tracker will fit just fine. Other years the switch fits are 1999 to 2004.


How do you replace the ignition lock cylinder on a 2004 Honda civic?

The ignition lock switch is found under the steering column on a 2004 Honda Civic. Remove the steering column and ignition switch. Loosen the mounting screws that hold the cylinder in place. Pull and replace the lock cylinder.


Where is the inertia switch in a 2004 ford sport trac?

According to the 2004 Ford Explorer Sport Trac Owner Guide : ( the fuel pump shut off switch / inertia switch is in the front passenger footwell , behind the kick panel access cover )


2004 f350 6.0LT no signal to starter?

Possibly a neutral lockout switch, possibly a bad connection, possibly an ignition switch.


Where is the immobilizer switch Mazda rx8 2004?

immobilizer is in the key and pickup ring on the ignition lock


How do you change the ignition switch on a 2004 gmc 1500 sierra truck?

how to remove cover to replace ignition lock cylinder and what type of tools do i need


How do you remove the ignition switch on a 2004 polaris 700?

i broke the key off in the ignition. got it out and got a new key. now when i try to hook up battery it trys to start even with the run switch off.


Where is the ignition switch on a 2004 Pontiac Grand Am?

The ignition switch is immediately behind and attached to the ignition lock cylinder. The ignition lock cylinder is where you place the key to start your vehicle. If you are haveing problems with your vehicle not starting and or turning the key, more than likely you need to replace the ignition lock cylinder. It is common for these to go bad in GM vehicles.