answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Where is the Kia Sorento CO2 sensor or fuel temp sensor?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How much does the co2 sensor affect the performance of the motor?

co2 sensor?


What causes the check engine light to come on in a 2004 Kia Sorento?

Try tightening your gas cap, We had the same problem and the gas cap wasn't tight all the way, We tightened the cap and it went off, after awhile. you may have to replace it, but tighten to allot of clicks and make sure its secure. Something to do with the pressure of the gas tank, but that's just one reason, there could be a CO2 sensor out or a fuel temp sensor, but try that and if it doesn't work go to Auto Zone and have them do a engine light check. they do it free of charge. or most auto parts dealers


What is the relationship between CO2 and temp?

there is no relationship


How much does it cost to get a co2 sensor repaired on a Honda 2001 CRV?

I want to replace the co2 sensor in my crv myself is it something I can do?


How do you change the co2 sensor on 2000 ford ranger?

What is a carbon dioxide sensor?


CO2 probe sensor?

A CO2 probe sensor measures gaseous carbon dioxide. It comes in two ranges, 0 to 10,000 ppm and 0 to 100,000 ppm.


At what temperature is CO2 added to water in order to make seltzer?

at room temp.


How to calculate fuel efficiency from co2 emission?

You can't, with just the CO2 emission figure.


What happens when carbonic acid is unstable?

Basically the CO2 releases into the air and water is left. Its unstable because CO2 is a gas at room temp.


What will happen if you cut the CO2 sensor off?

it will blow up


What ingredient is in baking soda that extinguishes a grease fire?

a bicarbonate of baking soda is Co2 Co2 displaces oxygen which is fuel for the fire no fuel no fire


How do you fix a co2 sensor for a 2000 jimmy?

disconnect the attached wire and unscrew the sensor. there is a gel that should be applied to the sensor before you replace it.