Fleetwood doesn't make their own chassis, and they've always offered a wide range of models and classes of motorhome. As is, we don't know if you have a Class A, B, or C motorhome, meaning we don't know what chassis it was built on, and we don't know what the engine is. This info would be necessary in order to answer your question.
Stuart Fleetwood was born on 1986-04-23.
check the inside of the frame rail on the drivers side.
Call Fleetwood directly. They will send you copies of wiring diagrams free of charge. Just need the Fleetwood serial number from the tag by the side door. Fleetwood was very helpfull and quick to respond to my request.
The Cadillac Fleetwood Brougham was first produced in 1977 and was produced until 1986. The Cadillac Fleetwood Brougham was a model of luxury cars manufactured by the General Motors (GM) corporation.
on top of oil filter plate it has one wire
1986 S10 Blazer 4X4 with 2.8L, The oil sender is located just to the right side of the oil filter and is a pain to get to...
oil filter on a Mercedes 190E 1986 is in the back of engine
Where is the location of the flasher relay for a 1986 325 BMW ?
The fuel pump is located inside the engine compartment, on the passenger's side, above the wheel well. It is about 4" in diameter ( a larger styled filter...). I looked in the location and all I can see it the A/C freon reservoir and other stuff. I do not see and cannot find the location of the fuel filter!
It is located on the drivers side of the vehicle, below seating area, rear of engine, mounted on the frame rail in fuel line.
not sure about those above 500cc but that and the 250 have them under the crankcase... you don't even have to remove any fairings cause the lower has an opening int to allow access to the drain and filter bolts... on the 1986 ninja 1000 the oil filter is by the exhaust pipe bottom of the engine you have to remove the exhaust to take the filter cover off its a paper filter.
The fuel filter for a 1986 Chevy G20 should be mounted on the frame under the van. The filter is an inline type and should be easy to change.