Its on the logic module (near the bottom) behind the passenger side kick panel.
Wiki User
∙ 14y agoBrian Soltis
manifold absolute pressure gas mixture.
They were not used in 1986
The MAP sensor is located on the passenger's side strut tower. There is a solenoid connected to it by a short piece of hose, and a hose runs from that solenoid to the intake. The MAP sensor will have a 3-pin electrical connector on it.
It is mounted underneath a bracket in front of the alternator on the side of the intake manifold.
It is on the passenger side inner fender almost directly behind the engine mount on that side.
how much is corperator for a 1986 isuzu pup 2.3l
The MAP sensor in a 1986 2.9 liter engine is a manifold absolute pressure sensor that measures the pressure inside the intake manifold. This information is used by the engine control module to calculate air/fuel mixture and ignition timing for optimal engine performance.
MAP Sensor is under hood, passenger side, upper firewall, mounted in control box.
No.
The sensor in the distributor is the crankshaft position sensor.
check oxygen sensor or map snesor, they are notorious for going out!
It does not have one, only fuel injected engines have one.