neutral safety switch is on the left side of transmission
Can you by-pass the neutral safety switch on a 1997 ford mustang 3.8
Left side of transmission!
left side tranny
in the console by the shifter
If it is a manual transmission it should have a clutch safety switch not a neutral switch. Usually found at the upper end of the clutch pedal under dash area
Neutral safety switches are usually at the end of the shift linkage vale at the transmission
Disconnect the 2 wires from the switch and connect them together
On the Transmission under the shift cable. Drivers side on top.
Probably the ignition switch. HavE IT CHECKED OUT> neutral safety switch......located under the shifter panel
Automatic transmissions have what is called a Neutral Safety switch. This eliminates the possibility of accidentally starting your vehicle in reverse or any forward gear. The vehicle will only start in park or neutral. Chris
If it's auto it is located in the centre column beside the shifter.
left side of the transmission bolted on by two 10mm bolts
To instal a neutral switch on the 1991 Topaz, kindly make reference to your users manual.
Neutral Safety switch. or equivalent.
if its an auto it should be where the linkage meets the transmission
if its a manual transmission its attached to the clutch pedal housing if its an automatic its the shifter
Neutral safety switch is bad.
To install the 1991 Ford Topaz neutral switch, just follow the instructions on the user manual.
On top of the steering column near the firewall under the dash. There will be a metal rod going into the bottom of the switch.
NO it has nothing to do with the engine dieing. You have other problems.
get the old neutral switch and throw it in the garbage. replace it with the new one and... DADA
Two different switches, two locations. 1. The Neutral Safety Switch prevents the shift leaver from been moved out of park unless the ignition is on and the break peddle is applied. On 1991 it is located inside the plastic counsel below the shift handle. Failure of this switch may cause your vehicle not to start. 2. Not to be confused with the above is the Neutral/Reverse switch. One of its functions are to activate the reverse lights. It is located at the end of the shift cable on the transmission (1991 AUTO) facing the rad. MC
First unplug the wire harness from the switch. Using the correct size socket (1" if I remember correctly) remove the switch counterclockwise from the transmission. Install the new one in reverse order.
Top of tranny under shift lever.
Ask questions, submit answers, leave comments
Earn points for using the site
Customize your profile
Already have an account? Log in