0
In the exhaust pipe below the manifold passenger side
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is the oxygen sensor located on a 1988 ford bronco ii?
in the exhaust manifold right before the catalytic converter
How do you replace ball joints on a 1996 Bronco 2?
You must mean 86 Bronco II? There is no 96 model.
Where is the vehicle speed sensor located on a 1988 bronco ii?
The vehicle speed sensor is located at the rear differential on a 1998 Bronco II. This also serves as the ABS sensor.Ê
Where is the oxygen sensor located on a ford bronco II?
It is on the H-Pipe that connects the passenger side and driver side exhaust, right before the cat.
What kind of diesel engine can you put in a 1984 Bronco II?
A small 86 HP 2.3L 4-cylinder diesel engine was offered through 1987 on Bronco II's. Bronco II's were made from 1984 to 1990. so if you find this engine it should fit your Bronco II. I researched this before i answered your question so i knew it would be correct!!! good Luck!!! A small 86 HP 2.3L 4-cylinder diesel engine was offered through 1987 on Bronco II's. Bronco II's were made from 1984 to 1990. so if you find this engine it should fit your Bronco II. I researched this before i answered your question so i knew it would be correct!!! good Luck!!!
What will cause Bronco ii will not fire?
i have an 86 bronco-II and my rotor cap had crack and the button had burn up. also the front fuel jet is clogged and running out of fuel. those were my problems. also the timing was out.
What would cause an 1988 Bronco II 2.9 V6 to have the Rear Anti-lock light come on and kill the turn signals?
i have a 86 bronco that cuts out when it reaches running tempature.
Where is the rollover switch located on a 1990 bronco?
i beleave the inertia switch is located behind the glove box or just below it.. that's where it is located on my 86 and my old 88 bronco II
Is a bronco 1 or 2 bigger?
There is the FULL SIZE BRONCO and then the Bronco II ( the Bronco II is smaller , eventually replaced by the Ford Explorer)
Where is the crank position sensor located on the engine of a bronco II with 2.9 engine?
it is on the front timing. near botton of crank pulley.
Why is my oil light on in my 86 bronco II?
check your dip stick to see if your engine oil is too low. also check oil sending unit
Gas tank size in a 1985 bronco ii?
23 gallon all Bronco II's are
