Just foward and at the 10:00 position from the oil filter.
7.3L does not have EGR Valve.
wher is the oil sending unit for a 1999 ford f250 v10 triten located on moter
The oil pressure sending unit is on the back of the block just above the bell housing. The unit screws in.
Look at the top of the engine at the rear center
Temperature Gauge Sending Unit The sending unit is located in the front section of the manifold in the vicinity of the thermostat.
The question should read 1989 Ford F250 7.4 liter engine...Location of Oil Pressure sending unit...
The oil pressure sending unit on a 302 ford is located on the block of the engine. It screws into the block and the sending unit goes on the end. The oil pressure sending unit on a 302 Ford is slightly above and to the left of the oil filter. I find it is easier to replace with the oil filter out.
It is located directly above the oil filter.
"http://wiki.answers.com/Q/Location_of_oil_pressure_sending_unit_1990_bronco_351"
If you suspect the sending unit may be faulty just replace it with a new one, they are not expensive but a little difficult to remove and replace.
Remove the oil pressure sending unit retaining ring. Remove the wiring harness from the sending unit. Poll the sending unit out of the engine.
Were is the oil pressure sending unit on a 95 mitsubishi miaage