0
You have to specify which engine. On my 1991 pickup with a 2.8 L V6 it's next to the oil filter. It's a 4.3 L V6, 89 S-10 Blazer!! Sorry about that!!
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Where is the oil sending unit located on 1997 Chevy s10 blazer 4.3 v6?
It is on the firewall end of the intake manifold below the distributor
Where is the oil sending unit on an 88 Chevy S10 Blazer?
Oil sending unit is under intake manifold, just behind the oil filter on the passenger side (difficult to see-use flashlight). Best option to change : Get everything to do an oil change, removal of the filter makes easier access.Read more: Where_is_the_oil_sending_unit_on_2000_Chevy_S-10_2.2
Where is the oil sending unit on a 1986 S10 Blazer small V 6 I bought the book and it doesnt show it?
It's located on the driver side of the motor, right below the oil filter. It is a brass looking thing.
Where is the location of oil sending unit on 1993 s10 chev pickup truck?
With a 4.3L engine, the oil pressure sending unit is in the back of the engine just to the drivers side of the distributor.
Where is the oil sensor unit located in a 1992 blazer S10?
Depends on which motor? On the 4.3 v6 it is next the dist.
How do you replace a tbi unit on a 2002 s10 blazer?
A 2002 S10 Blazer doesn't have throttle body injection (tbi).
The fuel pump is fine on my Chevy s10 blazer then why is my gauge still read empty?
The fuel pump may be fine but the sending unit may not be. The sending unit is probably the most common cause of fuel gauge failure.
Where is the oil pressure sending unit located on a 1988 Chevy s10?
At the rearmost section of the engine to the right of the distributor.
How do you change the fuel pump on a 88 Chevy s10 blazer fwd?
drain and remove the fuel tank. its grouped with the sending unit under the bung hole.
How do you change oil-pressure sending unit on 2002 S10?
If it has the 4.3 engine, I remove the distributor to gain access to the oil pressure switch.
How do you replace oil dipstick tube on blazer s10?
replacement of the transmission dipstick tub seal on a 1994 s10 blazer
How do you install fuel sending unit in 1995 Chevy S10?
how do you replace the fuel sending unit
