The Ford F450 OBD connector can be found on the top of the engine. The ODB connector will be near the air intake housing.
where is the turn single flashers on a 2008 f450
That bolt pattern is an 8 bolt pattern.
Your answer is NO... The F550 & F450 use a 10 bolt patern and the F250 & F350 use an 8 bolt patern.
it is located under the passenger side dash. it has a red and white and blue connector. first remove the plastic hush pad and it is visable. the squeeze each tab on each connector and slide the pcm out.
im wondering the same thing but i thin k it will
A F450 is much stronger it has more hp and torqe
do 1998 ford f450 have day time running lights
The 1993 Sable uses the old OBD l PCM (powertrain control module). It is located under the dash behind the glove compartment. If you are removing the PCM the electrical connector is on the firewall inside the engine compartment. There is a small bolt in the connector that you loosen as the connector is being pulled out. If you are looking for the diagnostic connectors, they are on the passenger side near the firewall, in the engine compartment.
It controls all the engine functions.
The 1994 Dodge Intrepids (3.3 and 3.5L engines) don't have a separate ignition module. The Powertrain Control Module (PCM) controls the functions of an ignition module. The PCM is located under the hood on the engine. It's held in place by a stud bolt and push pin. There's a "60-pin" connector attached to the back of the PCM. If you're removing the PCM, you'll need to remove the stud bolt and push pin, and unplug the 60-way connector.
There should be a connector behind the Powertrain Control Module. The PCM is located on the right hand side above the fender well, when looking at the engine bay. It is a square connector that a DRB II code reader plugs into.