0
The fuel PCM on a 1989 Mercury Cougar is located above the gas tank. It is on the rear fender wall on the driver's side of the vehicle. The Fuel Pressure Control Module is another way to say fuel pump.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
How do you adjust idle on a 2001 Mercury Cougar?
You can't - it's all controlled from the PCM.
How can you start a 1989 mercury cougar with a broken ignition switch?
how can you start a '89 mercury cougar with a broken ignition switch?
Where is the amplifier in a Mercury Cougar located?
Where is the radio amplifier in a 1989 mercury couger
How do you read the Oil pressure gauge on a 1989 mercury cougar?
with your eyes
Where is the dipstick hole on a 1989 Mercury Cougar?
it' on the left hand side by the exhaust
How do you change the ignition control module on 1996 mercury cougar xr7?
there is no ignition control module on the 1996 model its all through the PCM
How do you start a 1989 mercury cougar if the engine doesn't turn and the solenoid is good?
cougar 1989 no lighting in dash instruments or speedometer. Where do I look for an open circuit. Fuses all checked good.
When was Mercury Cougar created?
Mercury Cougar was created in 1967.
Is rear main oil seal 1 or 2 piece on a 1989 3.8l mercury cougar?
its one
What is the wheel bolt pattern for a 1989 Mercury Cougar?
Hi there, it is 5-108 mm. Hope this helps...
Where is the pcm in a 97 Mercury villager?
where is the PCM located on Mercury Villager 97
The door will not stay shut on a 1989 Mercury Cougar ls?
Adjust the striker if door otherwise aligned ok.
