IIRC it bolts into the top of the intake manifold, right between the carb and the valve cover, a little to the rear of the carb. You should find a rubber hose from it to the top of your air cleaner or vavle cover, I forget which. Note I always had success as they aged by removing them and cleaning them well with carb cleaner, so when you shake it you can hear the inside moving back and forth. I was still using my original PCV and passing smog with it at 250,000 miles.
Do use caution threading it back in. The intake manifold is aluminum and it is easy to cross thread the PCV valve into it. I did this once, and then had to remove the manifold until a friend heli-arc welded and redrilled and retapped my original manifold for me. A lot of wok for not taking enough care screwing it back in.
the pcv is on the drivers side valve cover towards the back of the valve cover.
Where is PVC valve located on 2008 Taurus
Its not A PVC Its A PCV Value Its not A PVC Its A PCV Value
The PVC valve on a 98 Eclipse is located on to or the valve cover. It is connected to the intake with a hose.
It's on the valve cover
The PVC valve on a 2001 Maxima is located in the rear valve cover just behind the throttle body.
where is the pvc valve located on a 1980 olds cutlass 3.8 v-6
where is the PVC fitting located at on the 2002 Nissan fronter with a supercharged 3.1 motor
where is the PVC valve on chevelet impala 2003
Pontiac PVC Valve is located on the Driver's side rear valve cover.
The PVC valve on a 2000 Maxima is located in the rear valve cover just behind the throttle body. REMOVAL # Grasp the PVC valve and pull it out of the valve cover
Type your answer here... in the tire