Geo

Where is the PVC valve on a 1997 Geo Prizm?

303132

Top Answer
User Avatar
Wiki User
2005-12-11 06:26:14
2005-12-11 06:26:14

Do you mean the PCV (Positive Crankcase Ventilation) valve? The PCV valve should be on the top of the motor, either in one of the valve covers or in the coverplate on top of the block.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

You don't fix it, you replace it.

User Avatar

It should be towards the passenger side of the engine stuck in the valve cover.

User Avatar

A 1997 Jeep 4.0L does not have a pcv valve. It uses an orifice in the top of the valve cover.

User Avatar

On the valve cover, with a large vacuum hose attached

User Avatar

the PVC vlave is located in a hole on the top of the valve cover next to the oil fill cap.

User Avatar

lcation pcv for BMW 1997 318i

User Avatar

ware is the PVC valve 2002 deville

User Avatar

The PVC valve is located on the top of the engine. It is on the drivers side of the engine close to the back.

User Avatar

To change PVC valve on a 1993 Nissan 300zx, first remove the oil dip stick and remove the tension clip from the PVC valve hose. Then remove the hose and the old PVC valve. Replace with a new PVC valve.

User Avatar

under the plastic cover between alternator and fire wall

User Avatar

Pontiac PVC Valve is located on the Driver's side rear valve cover.

User Avatar

A PVC Valve shuts off water A pcv valve is for positive crankcase ventilation in an engine

User Avatar

If I'm not mistaken, it does not have a pcv valve, my 2000 doesn't have one on it...

User Avatar

Where is the PVC valve on a 2002 Honda Civic EX?

User Avatar

Its Located be hide the Exhaust manifold, You have to take off the Cat, to get to it

User Avatar

Its located on top of the valve cover. Just grab hold of it and gently pull it out of the gromet its in, then pull the small rubber hose off and replace the PVC itself and push it back in from where it came.

User Avatar

where is the pvc valve located on a 1980 olds cutlass 3.8 v-6

User Avatar

where is the PVC valve on chevelet impala 2003

User Avatar

The PVC valve on a 2000 Maxima is located in the rear valve cover just behind the throttle body. REMOVAL # Grasp the PVC valve and pull it out of the valve cover

User Avatar

Where is PVC valve located on 2008 Taurus

User Avatar

PVC Valve Removal & Installation # Disconnect the oil separator hose from the PVC Valve. # Remove the PVC Valve from the grommet in the crankcase. Grasp the valve and gently remove it from the grommet in the passengers side valve cover. Remove the valve from the hose by carefully twisting it out. # Inspect the grommet for deterioration. To Install; # If necessary, replace the crankcase grommet. # Install the PVC Valve. # Install the hose.

User Avatar

PVC Valve Removal & Installation # Disconnect the oil separator hose from the PVC Valve. # Remove the PVC Valve from the grommet in the crankcase. Grasp the valve and gently remove it from the grommet in the passengers side valve cover. Remove the valve from the hose by carefully twisting it out. # Inspect the grommet for deterioration. To Install; # If necessary, replace the crankcase grommet. # Install the PVC Valve. # Install the hose.

User Avatar

The 2000 Toyota Avalon. PVC valve can be found on the air cleaner housing. The PVC valve will be attached to the back side of the air cleaner housing.

User Avatar

The PVC valve on a 98 Eclipse is located on to or the valve cover. It is connected to the intake with a hose.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.