On the passengers' side of the car you'll have to lift the plastic cover over the engine and look at the MAP sensor located at the passengers' end of the plastic cover (black in color and held in place by plastic clips--making up the entire MAP sensor assembly).
There are three wires connected to the MAP sensor. Remove the wire assembly first. The MAP sensor is removed by twisting it counter clockwise (a small pair of channel locks might assist in removing it). There is a large spring just under the MAP sensor that pushes down on the PCV valve. Remove the MAP sensor and spring and then you can access the PCV valve. You might need a pair of plyers to remove the PCV valve. Installation of the MAP sensor assembly is done by replacing the spring, putting the MAP sensor assembly on the spring, assure the assembly is in the counterclockwise position and twisting it clockwise to reinstall.
BR
were can i locate and replace a starter for a 1998 buick regal?
Possibly... Under the air filter
I'm assuming its like other buick regal models, around the passenger side windshield wiper.
How do you take off a radiator for a 98 Buick Regal
on the valve body
Look at the rear of engine right side
its on the front fuse box... its marked.
How do you remove 1998 Buick regal ls sun visor
4T60-E
On my 1998 Buick the valve was located near the battery. Mine was damaged during a hurried winter battery change.
Under the vehicle just in front of the left rear tire.