On top of the left (drivers side) valve cover.
If like my 2000, it is on the left valve cover. it is too cold to go out and double check.
The 2000 Toyota Avalon. PVC valve can be found on the air cleaner housing. The PVC valve will be attached to the back side of the air cleaner housing.
The PVC valve on a 2000 Maxima is located in the rear valve cover just behind the throttle body. REMOVAL # Grasp the PVC valve and pull it out of the valve cover
where is the PVC valve on a 2000 Chevrolet S-10 2.2 engine
The PVC valve on a 2000 Hyundai Accent enters the head of the engine. It can be seen by the air manifold towards the driver side of the engine.
In the middle of the drivers side valve cover.
It is in the top of one of the valve covers.
PVC Valve is located valve cover / crankcase cover. Removal; 1. Disconnect the oil separator hose from the PVC valve. 2. Remove the PVC valve from the grommet in the crankcase. 3. inspect the grommet for deterioration. To Install; 4. If necessary, replace the crankcase grommet. 5. Install the PVC valve. 6. Install the hose.
Small, usually grey, plastic elbow in the top of one of the valve covers.
On my 2000 Ford Explorer Sport 5-speed manual transmission 4.0L V6 OHV, the PVC valve is located as follows: Standing in the front of the vehicle looking at the right side of the engine on the top of the valve cover. It was stuck down in the valve cover with a tube running from it to the intake manifold. Hope this helps you out!!
ware is the PVC valve 2002 deville
If I'm not mistaken, it does not have a pcv valve, my 2000 doesn't have one on it...