It depends on the motor and speed of your transmission -- SOHC or DOHC. The DOHC (Canadian built) was put into 47% of the 2000 Dodge Neons during their second generation line. This means they are not like the SOHC models. Second, most had the 3-speed automatic transmission, some did come with a manual transmission.
Whether you have a newer model 4-speed or older 3-speed automatic impacts whether you will have these sensors or not. ALL 2000 Dodge Neons had the 3-speed automatic (as far as I can tell).
Complete computer control of the Dodge Neon automatic transmission began with the 2002 model and the 4 speed automatic transmission which definitely uses these sensors.
AGAIN, the 3-speed automatic transmissions found on the DOHC apparently do not have the same type of sensors as the 4 speed automatic on later built models.
The closest you can come to finding a manual for the 2000 Dodge Neon is with the 1999 manual as it is the only one that has the DOHC motor.
where is the engine speed sensor located on a 1999 dodge stratus 2.4 l
The vehicle speed sensor is located on the top center of the rear axle.
Top of the rear axle.
The output speed sensor is located on the back end of the transmission. The vehicle speed signal comes from the abs sensor on the top of the rear axle.
The speed signal comes from the abs sensor on top of the rear axle.
The speed sensor is located under the shift linkage on top of the transmission and is only held in place by one (10mm) screw.
It does not use an input speed sensor.
Where is the MAF sensor located on a 2000 Dodge Ram 1500
How can I chang the speed sensor in a infenti I30 model 2000?
It is located on the rear of the transmission, drivers side. 5 minute fix...
Behind the tranny
speed sensor is located on the top of the diff housing not on the transmission