with the hood open (on the 4G64 2.4 l), look for a vacumn line to the rubber air inlet. this line is connected to a plastic pc. pull it from the air hose. loosen the wire/rad. hose clamp from the air intake and follow these instructions:
1, Disconnect the negative battery c able.
2. Release the r etaining cl ips from the air cleaner
housing.
3. Loosen the clamp on the air outlet tube at the
throttle body.
4. Remove the breather hose and detach the connector from
the MAF sensor.
5. Remove the a ir outlet tube and upper housing
from the lower housing.
6. Loosen the hose clamp and slide the outlet
hose off of the MAF sensor.
7. Remove the four sensor-to-air cleaner housing
retaining nuts.
8. Remove the sensor from the air cleaner upper
housing.
the AIT is inside the MAF box
Where is the crank position sensor 0n a 2001 mitsubishi Galant
The intake air temperature sensor for a 2008 Mitsubishi Lancer is on the intake tube in front of the throttle body. It looks like a small metal box.
is just ther e to the rigth side
inside duct past air filter
Its in the distributor
Speed sensor
the speed sensor for 2004 Mitsubishi Galant is located on the front case of the transmission output shaft and speed sensor. It is approximately under the hood to the left of the engine.
Mitsubishi Galant, 2002, 4-cyl, O2 sensor, bank 1 sensor 1 (upstream)... PART NUMBER: MR506364
The manifold differential pressure sensor is on the top of the intake manifold. http://www.dsmtuners.com/forums/newbie-forum/102193-i-need-help-mdp-sensor-install.html
Inside the distributor
Where can I find the camshaft sensor for my car 2002 mitubishi galant es 4 clyinder
on the front side of the throttle body.