behind the dash on the passenger side.
Pull the airbag control module behind the center console. Alternatively , you just pull the ground to the module and it will be disabled.
Where is the ignition control module located in my 1992 Crown Victoria
DONT! Messing with the airbag module can kill you if the tool you are using gets sent back toward you when it fires off and inflates. there is nothing in the module you can fix anyway, leave it alone.
On a 1992 Ford Mustang : The fuel filter is underneath the vehicle in front of the fuel tank
The 1992 Chevrolet Corsica ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
Where is the ABS Computer Module located on a 1992 Lincoln Town Car
The 1992 Dodge Ram 250 ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
The module is situated in the arm rest where you store stuff unscrew it and you will find the module.
It should be someplace on the air intake that goes into the motor with 4 screws holding the cover on . At least that's where it is on my Mustang my Mass air flow module is
Inside the distributor cap
Mounted on top and inside the fuel tank.
The airbag system in the 92 Miata receives power from 4 circuits. I believe the main power is being provided via the Injector fuse (in the main fuse block under the hood). This circuit is "always on". This circuit also supplies power via an airbag fuse (also on the main fuse block) that charges the backup power module (actually a large capacitor) located under the steering column. This source is also "always on". The module also receives power via the Wiper Fuse and the Airbag fuse located in the fuse box under the dash on the drivers side. These inputs apparently enable the controller circuits as they are on only when the key is in the "on" position. Hope this helps.