Want this question answered?
prise lamp cover out by placing a small flat screwdriver in small recess of lense located near the light switch. replace bulb locate the two lense tabs into light unit and press lense back into place. easy job as replaced mine recently
In what sequence does it go back
you must be using the brakes too much, start using the handbreak more please.
This answer is in relation to a Matiz on a 51 plate. The surround is removed by unscrewing 4 screws around where the speedo display is situated, and another screw at the back of the compartment below the radio. after this the surround pulls off. To refit, the surround just pushes back on and replace the screws.
You might need to replace the back-up light sensor, located under the dash, by the brake pedal. The correct term is "brake light switch" instead of "back up light sensor." And yes, it is located above the brake pedal.
I was told by my parts guy that the back up light switch is the same as the reverse light switch.
the back up light switch is located in the gear shifter console
switch is on the transmission
Maybe a security switch...inside you find a thermo reset...like that you find in hidraulics...there's no note in the manual of Matiz....this device swith off the 12 Volt of Fuel pump alimentation maybe when the car crash and the temperature rise , to avoid fire .I had some problem with this because the car did't wont start alternatively and random..I find this swith following the cables that are under the back seat of the car and go to the fuel pump.The yellow cable is 12 volt from battery thru the fuel pump relay.Aerosmith
You can try to reset your brake light switch by unplugging the brake light switch and plugging it back in. If that does not solve your problem you will need to replace the brake light switch.
the back?
They make a SPECIAL glue/grease that goes on the back of the pad- NOT THE ROTOR SIDE.also MAKE SURE ALL the ANTI- RATTLE clips are on the pads & the pad Mounts.(end where the pad slides)