Chevy S-10

Where is the backup light switch on 1997 Chevy S-10 standard and how would you replace it?

747576

Top Answer
User Avatar
Wiki User
Answered
2005-08-08 21:08:12
2005-08-08 21:08:12

Should be in the side of the gearbox (assuming 5-speed) there will be 2 wires and usually a shim, put new one back like old one.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


Standard or automatic transmission, they both are mounted to the transmission.


Fuse, bulb, or the switch mounted on outside of tranny casing.


depends if it is standard transmission it is located on the left side of the transaxle.


Not sure on how to replace it, but it is located INSIDE your center console (which will need to be removed if you cant get to it by removing the shift boot) it is a pressure switch at the base of the handle...


replae backup light switch on transmission


how to replace an ignition switch for 2005 chevy equinox


How do you replace a break light switch on 1995 Chevy Tahoe


How do you remove and replace wiper switch on 2002 Chevy Cavalier


replace ighnition switch for 1985 chevlot



If you look at the drivers side of the transmission were the shifter linkage hooks to it you will see an electrical switch behind it. That switch controlls the backup lights among other things.


The backup light switch is generally located on the Transmission. If you would like to see one then follow the link to RockAuto.com and locate your Truck. Hope This Helps.


that is usually mounted on the transmission case


How do i replace the headlight switch on a 03 trailblazer in detail. Such as what needs to be removed befor the switch is installed and with what tools .


how do you replace3 dimmer switch 1987 chevy silverado 4 x 4


you can find the switch on the back of the brake pedal.


You switch the carborator with the ac and then rewire the inside to the dashboard


The flasher is built into the hazard switch. You need to pull the dash to replace the switch. It costs about $45 & is available through Chevy dealers. Mike The flasher is built into the hazard switch. You need to pull the dash to replace the switch. It costs about $45 & is available through Chevy dealers. Mike


How do I install a turn signal switch for a Chevy 2000 Impala? WHere is the old part that I need to replace?


The neutral safety switch, on your 1999 Chevy Tahoe, simply plugs in. Unplug the neutral safety switch and replace it with a new one.




The trim ring around the switch, unscrews, and the switch pulls out thew back.


Its pretty easy, as long as you have or have found a new switch. You just have to go to your local Chevy Dealer


how do you replace ignition switch on a 1992 Chevy cavalier 2.2 4 cylinder



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.