the bleeder is on the outside of the backing plate this means u must get underneath the vehicle to see it locate where the brake fluid line goes in and the bleeder will be right next to it
Remember, keep the master cylinder full so you don't suck air into the slave cylinder. Then you put the fluid in the slave cylinder.
if it is standard trans it does
The slave cylinder would be the part at the transmission.
on the passenger side of the transmission
Bad clutch slave cylinder or failed soft hose from master to slave cylinder.
Does my 1995 Toyota Paseo have a clutch cable
Try bleeding the slave cylinder, otherwise there is no adjustment.
The slave cylinder is located on the driver side of your bell housing going to your motor. Its a cylinder about the size of a roll of quarters.. maybe a little bigger.
Bleeding the cylinder may solve your problem. You bleed the cylinder the same way you bleed brakes. Have someone push and hold the clutch pedal down. Open and close the bleeding petcock to let any air out. Person then lets clutch back up. Do this until all air is removed from system. Try first gear then. If still a problem, (I'm not sure here) is it possible to adjust your clutch by lengthening/shortining the clutch push rod in between the slave cylinder and the clutch fork? Try that if it adjusts. Most dont but I don't know of hand about yours.
It's the slave cylinder.
is it main cylinder or clutch slave sylinder? if is main then its behind there clutch pedal and if its a clttch slave ots ill be on gear box or near there. hi
Whenever you are having a problem with the clutch disengaging the engine from the transmission it is advisable to bleed the clutch slave cylinder. If the clutch can't be operated by bleeding the slave cylinder then the clutch master cylinder is gone and should be replaced.