Want this question answered?
It is either on the door jam on the driver's side or in the glovebox.
They are bolted from the inside of the door.
There are usually only 1 blend door on a truck. This also goes for a 2005 Chevrolet Sliverado.
To the left of the steering wheel where the door meets the car.
There is actually 3 blend doors on the plenum. The blend door actuator is on the top of the case. It controls heat and cold air.
The 1990 Chevrolet Suburban door panel is held in place with 14 retaining clips and two screws. Remove the screws, that can be found near the door handle. Pry outward on the retaining clips to remove the door panel.
Remove the inside door panel from your 1994 Chevrolet. Remove the linkage from the door handle. Remove the door handle retaining bolts. Reverse the process to install the new door handle.
The blend door actuator on the '94 Suburban is located just above and to the right of the accelerator pedal. There are 2 - 7mm screws that hold it in place and 1 wire harness connection.
There are no ajustments for the hinges they are welded. NEUTZ
Open the drivers side door and look on the dashboard part (the part that gets covered by the door when closed) for a removable panel. That's where the blinker fuse is located.
You must take the entire black housing out. The screws are located underneath the trim panel on the inside of the door. A lot of the handles break in cold weather. http://www.1aauto.com/1A/DoorHandleExterior/Chevrolet/Beretta/PLP1090050/37746 you can buy replacement handles at this website
All of the air conditioner door are located in the evaporator case. They have electric motors that go bad. You may have to remove the glove box to gain access.