The Turn Signal 'blicker' relay is located on the same bracket that holds the ECM and other relays, like the Main relay, Fuel relay, and Horn relay. The fuses are also attached to this same main bracket. The 'blicker relay' is the three-pronged relay in the center and it is not easy to see nor replace from under the dash. Easier way to replace the blicker relay is to remove the left dash radio speaker cover and then remove the speaker. Then remove the two bolts (that also can be unscrewed with a Phillips ( "+" pattern) screwdriver) that hold the entire bracket that the ECM and all the relays are attached to. INSURE THE BATTERY IS DISCONNECTED to prevent blowing the expensive ECM ! Then slide the entire assembly forward towards the firewall and disconnect the connectors (do not force connectors off because some, like the ECM connectors, have plastic clips that have to be depressed while wiggling the connector free). Unscrew the fuse box to be able to remove the entire bracket assembly and you can then easily replace any relay or even the ECM.
Where can i buy a fuel pump relay for 1990 1.6 geo tracker
does 1990 geo tracker have air bags
How cha~ge oil tra~smisio~ of a geo tracker 95
Yes it should.
i want to know how to rebuild a manual transmission for a 1990 Geo Tracker 4x4
Go to Google.com and type in the words "1990 Geo Tracker firing order" and it will get you to a site that will tell you.
The 1990 Geo Tracker IAT sensor is located on the top of the transmission. The IAT sensor will be near the back of the transmission.
what is the timing specs for a 95 geo tracker
0.028 geo tracker 1990, 8 valves 2 doors
Suzuki.
inside the fuse/relay center probably under the hood
8 degrees BTDC