Want this question answered?
where is the heater block on a 2004 saturn vue?
I can't find my block heater plug on my pontiac G6 2006,,,Where is it? Maybe it does not have a block heater.
Usually the block heater is in place of the passenger's side rear freeze plug
you have to buy the plug-in cord (for the block heater) separately. Block heater is about $34.00 CDN and the cord is about $75.00 CDN. The cord has the regular end to plug into your electrical socket and the other end has a special plug end for the heater.
The block heater cord was an add on accessory. If equipped, it is located on the passenger side of the engine
plug a block heater plug into any household 120 electrical outlet just like plugging in a heater in your house
IF there is a block heater (Only some models had block heaters) you will see the electrical plug wound up somewhere under the hood. Follow that wire back to where the block heater goes into the block. If your Saturn doesn't have a block heater, and you want one, there are several options. You can purchase a block heater that replaces the engine freeze plug. That requires installation by a qualified mechanic since the old freeze plug must be removed to use that style block heater. You can purchase an engine heater that fits inline with the coolant system. That just requires cutting a hose and splicing in the engine heater. You can purchase an engine heater that sticks magnetically to the engine while in use. Be careful with that model since you should remove it if it's hanging down from the bottom; it could become a hazard when you're driving.
The 1995 Cadillac block heater plug can be found on the right hand side of the engine. The block heater plug will be near the back of the engine.
The 1997 Geo Tracker block heater does have a frost plug. The Frost plug will be a few inches below the block heater.
It is located just above the starter, which is on the passenger side of the truck.
Drain coolant from radiator and engine block Remove passenger's side rear freeze plug and replace with block heater kit
Remove and engine block expansion plug. Insert the block heater. Seal the block heater. Attached the wiring harness to the block heater.