Its behind the glove box disconnect the negative battery cable remove the glove box assembly,lower right side instrumental panel trim cover and right cowl trim panel,as required.disconnect the blower lead wire connector If the vehicle is equpped with air conditioning the 2 vacuum lines from the recirculation door actuator and postition the actuator aside remove the 5 screws from around the blower housing and separate the blower housing from the unit remove the 3 screws that secure the blower assembly to the heater or air conditioning housing and remove the assembly from the unit.remove the fan from the blower motor by removing the spring type retaining ring from the center of the blower wheel.note the location of the fan-to-blower motor assembly for correct installation
IT IS LOCATED UNDER THE WIPER COWLING BEHIND THE WASHER BOTTLE AND HAS TWO SCREWS HOLDING IT IN
On my 91 its behind the engine in the center of the firewall
The blower motor on a 1992 is located under the hood. It is on the firewall on the passenger side.
It is located on the blower motor housing and is white in color. You have to take the blower motor assembly out as far as I know to get to it.
The problem is most likely a faulty blower control module.
The first step on how to change the motor on a 1992 Chrysler LeBaron V6 3.0l is to position the vehicle to where you can get the hoist in and out.
under the blower motor housing. to the right
Probably the blower motor resistor is shot.
Yes. First check to see that you have 12 volts to the blower motor. If yes, blower motor has probably failed. If no, it may be the blower motor relay or there is a speed control resister pack causing your problem.
87 octane unleaded
usually mounted on or next to blower motor
The blower motor is on the right side of the engine compartment on the firewall.
Looking at the picture in my Haynes repair manual it looks like the blower motor resistor is in the engine compartment mounted just to the right of your blower motor when looking from the front of the Explorer - Helpfull
Unlock the doors with the key.
It is behind the rear seat.
It is located behind the window washer reservoir. Actually the blower resistor is behind the window washer reservoir. Sorry
The wiper motor on a 1992 Chrysler LeBaron won't work if the motor has seized up or the fuse has blown. The switch inside the cabin or the wiring can also come loose and cause this problem.
Most likely and bad blower motor resistor.
also check the AC clutch check for blown fuse... a possible bad blower motor relay
Unlock the driver door with the key.
The motor will be located under the hood at the far right corner.
The blower resistor is located behind the dashboard. It is found behind the heater near the center of the vehicle.
The Blower is mounted under the passenger side glove box high on the firewall
CHECK THE BLOWER HOUSING. IT SITS INSIDE THE HOUSING AND IS SECURED BY SCREWS ON TOP OF THE BLOWER HOUSING.
It is screwed into the exhaust manifold on the rear of the engine.