Chevy Silverado

Where is the blower motor on a 1990 Chevy silverado pickup?


Top Answer
User Avatar
Wiki User
2008-12-12 01:36:46
2008-12-12 01:36:46

It is under the dash where the passagers feet go.


Related Questions

Yes, located in the blower motor resistor pack. Follow the wires backward from the blower motor to find it.

the blower motor relay is located next to the blower motor it is connected to the motor by a purple and black wires

Should be near or attached to the blower motor

its next to the blower motor behind lower of glove box

Under the hood, passenger side firewall, not far from the blower motor.

under the dash on the passenger side.

The Chevy SBC 5.7L 350cid V8 was the standard

how to install a blower motor for a 1994 Toyota pickup

It is located on the passenger side below the dash. A 7-wire harness goes to it. It is next to the blower motor, which is circular in shape.

If yourtalking about the heater blower, I believe they are hidden behind the glove box inner liner.

On 03 silverados i belive the blower motor relay is internal to the blower motor resistor. i could be wrong though, check the underhood fuse/relay panel for one.

you have to remove the glovebox, its behind that, it has 2 bolts and a "connector", should be on the left side of the blower housing.

It's the fuse for the blower motor in your dash (air vents)

The blower motor relay only operates the high speed function. That relay would be in the fuse/relay center under the hood.

The blower motor is located under the passenger side of the dash panel.

305(5.0) or 350(5.7) most likely a 350

On the right side under the dash, behind the glove box.

Remove the wiring harness from the 1996 Chevy Cavalier blower motor. Remove the blower motor retaining bolts. Remove the blower motor fan. Reverse the process to install the new blower motor.

Remove blower motor 97 GMC jimmy

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.