Want this question answered?
Behind the glove compartment.
the body control mod. is located on pass. side under dash behind glove box
Yes, in the transmission.
The AC control head is the control panel for the heater/air conditioning in the vehicle.
connected to the brake pump behind the air filter on the right side of the engine compartment
Under the drivers seat. On bottom of s.eat, not floor
ecu? Do you mean ecm, Engine Control Module?
On the 99 Olds Intrigue, the camshaft sensor is located on the rear of the engine. It is just above the starter.
Only the Olds Intrigue with the 3.5 L
First of all disconnect the battery before starting with the other steps. After this remove the lower steering column and the knee blocker reinforcement to be able to access the cables connecting the Body Control Module. Remove the two wire connectors which are located at the bottom of the module then unscrew the bolts that are holding the junction block to the mounting bracket of the dash panel. After this was done, remove the junction block itself and remove the screws that are holding the module to the junction block. Next slide the Body Control Module downwards out of the junction block. This will disengage the guide studs on the block. To install a new BCM module, do the above steps in the reverse order.
The camshaft sensor on the 99 Olds Intrigue is located on the engine block. It is under the starter, which has to be removed to locate the camshaft sensor.
check fuse. they are all conected.