Hi have you found out the answer to this question?
Im trying to fit a carseat into my Ford laser but can find the bolt
85-91 nm or 63-67ft.lbs
56-60 ft-lbs as per haynes manual to 98
remove you battery box and right below ur intake u will see a wire running to a bolt remove that bolt and the bolt below that and you will have to go underneath the car to get the starter out
The bolt in found in a Ford Festiva in the boot on the left hand side on the inside of the boot not far from the back of the rear lights panel. There is a bolt there with screws on it. Not sure how it works but its a start.
Ford bolt 2n386 is the bolt for holding down the brake calipers.
Bolt has "laser vision, super strength, the super bark, and speed"
5x114.3 is the bolt pattern for the ford edge
The bolt pattern on Ford Fusion is 5x114.3
Look under the hood for it. It is held on hy one bolt only.
Behind the radio, mounted to the left with an 8mm bolt.
If you have a hatchback their are usually 3 anchor points and you can find them on the inside of the boot between the floor and where the latch is, just look for a small round plastic disc about the size of a 50c coin, you just pop it out. You can also visit racq or some anmbulance stations will install one for you.
bolt pattern for 2000 ford ranger & ft pounds