Unhook your battery, locate your starter........ which should be behind A/C compressor there are 4 bolts, two in the front and two behind the starter.
Where is the thermostat located on a 1987 Buick LeSabre?
Get a manual on your car from the parts store or from AUTOBOOKSONLINE.COM. This is not a job for the backyard mechanic as you have to hold the engine while the trans is pulled.
where is the relay located on a 87 lesabre
inside of the alternator
I have a 1990 lesabre and im 90% sure its a 16 gal.
depends where the leak is, and how bad it is.
no fix,replace with new only.
How do you change the starter on a 1987 virago motorcycle
autozone.com has alot of helpful info
The lock assembly is located in the center of the door panel of 1987 Buick LeSabre. Use of a Slim Jim is only legal for locksmiths and law enforcement officers.
It is with all of the relays in the center of the firewall under the hood.
Old age Frozen or misaligned pulley
Fuse panel. Open and read your owner's manual.
All of them, if you want a blazing fast car, go with a 1987 Buick LeSabre, or a 1994 Toyota Rav4
the filter is located right under the driverside just in front of the rear wheel
it is on the passenger side of the engine compartment, and is part of the big silver accumilator.
disconnect the battery, then the wires from the starter. Then remove the bolts holding the starter to the engine.
Mine is 1990 LeSabre,is there any difference too rule? Too take the dood panel off drivers side front!? Too get too window/track?
Remove the positive battery cable from your 1987 Chevrolet Blazer battery. Remove the starter cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
You can purchase a Hyanes repair maunal for about 10 dollars. It will have pictures and step by step instructions on how to repair your brakes.
Theres a small opening in what appears to be the airconditioning duct work middle of dash under ash tray you have to practically get on the floor on your back to see it.
You need a ball joint press to do that job. Remove old ball joint with sledge hammer and press new on into control arm.
I don't know what you are calling a sensor box. If you are refering to the computer, go to auto zone and have the codes read free. GoodluckJoe