cam censer is in the distributor the crank censer is between the engine and the transmission on passenger side 2 bolts hold it in place.
The cam sensor is inside the distributor. The crank sensor is on the top driver side of the bell housing.
yes
on the crank near the back of th motor you will have to pull the crank out of the motor inorder to change the wheel i have a 2000 gc and just had to do this it is not an easy task
Yes
It should fit but, the crank position sensor produces a signal by referring to the flex plate. In 1991 Jeep went to a Chrysler fuel injection system and the windows that the crank sensor reads are different. So in other words it should bolt up but then it will not start.
its on the bell housing,on the tranny,driver side.towars the top,held in by one bolt.sets inside the bell housing.
somebody broke or didn't connect the crank sensor
driver side on the back of the motor where is crak sensor on 94 jeep 4.0 grand Cherokee
its been my experience , if its a 3.4lt, it has two sensors for the crank, one in the block. and one in front cover near crank.
in a toilet
yes
Bad crank position sensor
on the 4.0 jeep, if it cranks, but wont start, try replacing the crank sensor, located at the top rear of the engine, at the transmission
Usually a crankshaft sensor is located on the bellhousing of the transmission
crank or cam shaft position sensor is sometime the issue.it will not fuel if it cannot find the position of the cam or crank
The cam position sensor is in the distributor. on both engines. The crank postion sensor goes through the top left of the bell housing on the 4.0L and the top right on the V8.
It is on the top passsenger side of the bell housing.
It is on the top passenger side of the bell housing.