Saturn (car)
Nissan Pathfinder
Crankshaft Sensors
Ford F-350

Where is the cam position sensor for 1996 Saturn?

464748

Top Answer
User Avatar
Wiki User
2006-09-02 23:33:11
2006-09-02 23:33:11

there is no cam sensor on any 1996 saturn- i presume there is a code p0341 set- check the 1/4 plug wires, plugs, and coils

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The 2003 Saturn L200 does not have a camshaft position sensor.

User Avatar

The 94 and 95 are the same,no cam sensor.1996 and 1997 are differant in one way.The 1996 and 1997 have a cam sensor. .The 97 has a cam sensor and the 94 does not.The 1996 has a cam sensor too.

User Avatar

The cam sensor is inside the distributor.The cam sensor is inside the distributor.

User Avatar

There is a problem with the cam sensor or the wiring to it.

User Avatar

The camshaft position sensor is inside the distributor.

User Avatar

The 1996 BMW 328 camshaft position sensor is located on the front of the cylinder head. The camshaft position sensor should be labeled as such.

User Avatar

Cam position is taken from the distributor, there is no external cam sensor.

User Avatar

The cam position sensor signals the fuel injectors to inject. The crankshaft position sensor signals the spark plugs to fire.

User Avatar

Next to the cam gears beneath the valve cover

User Avatar

the cranck sensor is on front of engine it reads the teeth on crank pulley.the cam sensor is on top of same side of engine.

User Avatar

Cam position is taken from the distributor on this vehicle, there is no separate cam sensor.

User Avatar

Camshaft position sensor intermittent.The cam sensor on the end of the head has failed.Camshaft position sensor intermittent.The cam sensor on the end of the head has failed.

User Avatar

It's in the dist. The dist. itself is the cam sensor.

User Avatar

CMP= Cam Shaft Position Sensor.

User Avatar

CPS is located above the starter on the back side of the engine held in with a 10mm bolts.

User Avatar

the cam sensor is locate at the front of the engine.

User Avatar

The cam sensor is the "pick up plate" in the distributor, under the rotor.

User Avatar

The cam position sensor is attached to the distributor, under the distributor cap. It is held in place with two screws.

User Avatar

cam sensor senses position of cam .coil sensor operates coilboth 2 entirely different parts of engine

User Avatar

That is the only electrical Item that is in the distributor. Remove the cap and rotor and you will see the cam senor.

User Avatar

I would like to know where the cam sensor is on a 1999 pathfinder and is there one or they calling it a crank shaft sensor The cam shaft position sensor is located in the distributor.

User Avatar

Cam position is taken from the distributor, there is no separate sensor near the cams.

User Avatar

Cam sensor on 1996 Dodge intrepid 3.5 V6 is on the driver's side on top where the cam gear turns on the front of the engine.. Usually has a 90 deg. connector for the wires.. MUST be air gapped correctly to work proplerly.. DO NOT Bottom the sensor out against the cam gear unless the new sensor has a card board disc glued to the end of the sensor to set the gap... Good luck!


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.