It is located on the left (drivers) side of the engine near the back. It is located on the engine side of the head. You may have to move the throttle cables to get to it and I believe that the bolt holding it is a 8mm. Removing the bolt is not fun and will take some time and patience (small hands will help). Before removing the sensor you need to remove the uppermost cam bolt. If not it will prevent you from removing the sensor or possible damaging the new one. The bolt slightly penetrates the hole for the sensor. Take special care disconnecting the old sensor from the harness as this can prove difficult, they don't give you much to work with and the wires will pull out of the plug (I know).
where is the cam sensor on a 2001 Lincoln 3.9 liter v-8? \'Where is the cam sensor on a 2001 Lincoln v8\'
On a single cam ford focus 2000-2001 the cam position sensor is below the pcv valve. If looking at the engine it is on the right side, rear, about a 3inches from the top of the engine.
what is location of cam positioning sensor on 2005 scion xb
Cam position is taken from the distributor. There is no separate cam sensor.
The 2001 Lincoln Navigator has double overhead cam (DOHC).
the cam positioning sensor is on the passenger side of the engine block near the bottem. the best way to access is through the wheel well.
have never heard of a cam angle sensor. the cam does not change angle.it stays put in the bearings
the cam position sensor shoult be on the passanger side of the car on the cylinder head. it sticks out of the end of the head at the end of the intake cam.
The cam sensor on a Dodge 4.7L is under the front outside of the passenger side cylinder head.
There is not a cam sensor on a 2001 Nissan frontier with a 3.3 litre engine.
have the cam positioning sensor checked
passanger side of water pump