0
Where is the cam and crank sensors on a 1994 Jeep Grand Cherokee Limited 318 motor?
Pecospete
cam censer is in the distributor the crank censer is between the engine and the transmission on passenger side 2 bolts hold it in place.
Wiki User
∙ 13y ago
Wiki User
∙ 13y agoThe cam sensor is inside the distributor. The crank sensor is on the top driver side of the bell housing.
Add your answer:
Earn +20 pts
I own a 2001 Jeep Cherokee that didn't start the day after a mechanic did a tuneup on it he replaced the crank sensor do 2001 Jeep Cherokees have crank sensors and if so is that a legit diagnosis?
yes
Where is the crankshaft tone wheel on a 4.7 Jeep Grand Cherokee located?
on the crank near the back of th motor you will have to pull the crank out of the motor inorder to change the wheel i have a 2000 gc and just had to do this it is not an easy task
Could the Crank Shaft Position Sensor cause a 1999 Jeep Grand Cherokee Laredo to stall driving up the road doing 65?
Yes
Will a flex plate for a 1990 Jeep Cherokee Laredo fit on a 1992 Jeep Cherokee Laredo?
It should fit but, the crank position sensor produces a signal by referring to the flex plate. In 1991 Jeep went to a Chrysler fuel injection system and the windows that the crank sensor reads are different. So in other words it should bolt up but then it will not start.
Where is located the crank position sensor on a 1996 jeep grand Cherokee Laredo?
its on the bell housing,on the tranny,driver side.towars the top,held in by one bolt.sets inside the bell housing.
Why wont 94 jeep grand Cherokee limited 5.2 wont start and no spark after changing transmission?
somebody broke or didn't connect the crank sensor
Where is crank sensor on 99 jeep 4.0 grand Cherokee?
driver side on the back of the motor where is crak sensor on 94 jeep 4.0 grand Cherokee
Where is the crank sensor located on a 2003 Grand am?
its been my experience , if its a 3.4lt, it has two sensors for the crank, one in the block. and one in front cover near crank.
Where is the output crank sensor located on a 1995 jeep Cherokee grand Laredo?
in a toilet
I own a 2001 Jeep Cherokee that didn't start the day after a mechanic did a tuneup on it he replaced the crank sensor do 2001 Jeep Cherokees have crank sensors and if so is that a legit diagnosis?
yes
What would cause your jeep grand Cherokee to turn over but not start?
Bad crank position sensor
What would cause your 1993 Jeep grand Cherokee Limited 4.0L inline 6 to not start?
on the 4.0 jeep, if it cranks, but wont start, try replacing the crank sensor, located at the top rear of the engine, at the transmission
Where is the crank sensor on a grand Cherokee Laredo 4.7 engine?
Usually a crankshaft sensor is located on the bellhousing of the transmission
2001 jeep grand Cherokee won't start sometimes?
crank or cam shaft position sensor is sometime the issue.it will not fuel if it cannot find the position of the cam or crank
Where is the cps located on 1997 Jeep Grand Cherokee limited?
The cam position sensor is in the distributor. on both engines. The crank postion sensor goes through the top left of the bell housing on the 4.0L and the top right on the V8.
Where is the crank position sensor located on 96 Jeep Grand Cherokee Lardeo?
It is on the top passsenger side of the bell housing.
Where is the crank position sensor located on a 96 Jeep Grand Cherokee Laredo?
It is on the top passenger side of the bell housing.
